How to replace the valve core of a single cooling faucet?

Method 1:

First, close the main water valve

2. Then remove the red and blue symbol around 8mm from the faucet handle

3. Use a slotted screendriver to loose the fixing screencounter clockwise and remove the handle

4. Use a monkey wrench to open the valve core of the faucet, open the upper part of the land with a wrench, and take out the ceramic valve inside

Method 2:

First, close the main water valve

2. Use a screenriver to pierce under the handle of the faucet and pry it up from left to right Pry it on one side, slowly and ever, so that the valve core can be removed

Method 3:

First, close the main water valve

2. Unscrew the blue cover on the right handle

3. Use a Phillips screwdriver to loose the screws inside, remove the handle, and receive the valve core

4. Use a monkey wrench to unscrew the valve core

How to replace the valve core with a new one?

1. After removing the valve core, you will see a blue rubber ring at the bottom of the valve core Generally speaking, the bottom of the left valve core is made of red rubber, while the right valve core is made of blue rubber

2. So when replacing the valve core on the right, use a blue ruler valve core After installing the valve core, insert the handle and adjust the direction of the handsheet When the handle is fixing both sides, it is turned off and the direction of the person standing is boiled water

3. Install the screws and cover the blue cover on the right, which will replace the new valve core

How to replace the valve core of the hot and cold faucet?

1. Preparatory work

a. The valve core is broken, you need to purchase a new valve core first, and the new valve core must match your faucet

b. Based on the drafts of your own faucet, prepare a flat or cross screenriver, hats an Allen wrench, and then prepare a pointed nose suppliers and a small knife

Note: In general, you can buy the valve core from a store of the same brand of faucet, and you can basically buy it

2. Remove the hot and cold water buttons

a. Before replacing the valve core, it is necessary to first find the water source switch of this faucet, and then turn it off to avoid spraying water during replacement

b. Then find the hot and cold Lincoln, the water button may be a plastic cap Gently try it off with a small blade so you can see the scratches inside

3. Remove the handle

a. After flipping on the hot and cold water buttons, check the shape of the trees, where they are straight or cross shaped, or may be hexagonal trees Then decide which screendriver to use, throughout an Allen wrench Remove the screws inside the hole with a screendriver, and then remove the handle of the faucet

4. Removing the valve core

a. After removing the handle, you can see the valve core inside Some valve cores also have a fixed outer shell cover Just remove the cover

b. Then you can see the clamp that fixes the valve core There are currently four classes on the clamp Use the two classes on both sides of the pointed nose suppliers to clamp them, and then rotate lockwise to remove the clamp

5. Device

a. After removing the card, the damaged valve core can be removed

b. Then install the new valve core device, reverse the previous process, and reinstall the other components

c. After installing the faucet handle, check the water source valve to see if there is any leakage If there are no problems, lock the handle tightly and install a cold and hot water plastic cap

Article source: Kaiping faucet http://drip-certified.com/