We often find that the faucet still leaks after being tightly closed, and it may be from the outlet or joint of the faucet What should I do if the faucet leaks? In fact, the structure of the faucet is very simple, and the problem of water leakage can be solved by replacing the sealing gas such as the axial or triangular sealing gas inside the faucet Below are four common treatment methods for water leakage

Three common leakage conditions

1. The element of water leakage at the outlet: it is caused by the wear of the axial gas inside the faucet Use suppliers to loose and remove the global bolt, remove the shaft gas with a clamp, and replace it with a new shaft gas

2. The leakage factor in the lower gap of the faucet bolt is caused by the wear of the triangular sealing gas inside the land You can expose the tea and remove the bolt head, then expose the land and remove it. Then, take out the triangular seal on the inner side of the land and replace it with a new one

3. Accepting water leak at the joint: Basically, the cap nut is loose at this point, you can right the cap nut from the beginning or replace it with a new U-shaped game

Four processing methods

For the repair of water leak at the faucet joint, the factors that may cause water leak are nothing more than the damage to the sealing tape that fastens some of the faucets (fixing screws) There are more, all you need to do is use a supplier to remove the faucet and roll a new water proof tape from the head where the screws are fixed The following is the repair process:

First, right the faucet and use a supplier to rotate the faucet counter clockwise to remove it

Turn the threaded hole forward and use wind imprinted tape to wind it up 5-6 times clockwise on some threads

Check if the faucet is properly adjusted and uses a water bolt suppliers to bolt it in clockwise direction

After the equipment is completed, turn on the main switch and try it out, condensing to see if there is still water leakage

Precautions

If the faucet is found to have a decrease in water volume, it may indicate a water leakage situation, as the sealing disk of the single gun faucet is stuck with sand and level This situation is still the case with a professional repair disassembling the faucet to clean it up, but if the rubber pad is damaged, it is necessary to replace it. Generally speaking, Accurate use of a faucet means not rotating the faucet too tightly The faucet rubber pad can maintain a lifespan of 7 to 8 years

Article source: Kaiping faucet http://drip-certified.com